Shenzhen Upcera Dental Technology Co., Ltd.
Shenzhen Upcera Dental Technology Co., Ltd.
Add to Cart
Dental Laboratory Milling Supplies Core Dental Ceramics ST 16 Pre - shaded
Specifications:
ST COLOR block: suitable for single shaded crown and bridge with VITA classic 16 shades(A1/A2/A3/A3.5/A4/B1/B2/B3/B4/C1/C2/C3/C4/D2/D3/D4)
| ZZ CAD/CAM | D95-10 | |
| D95-12 | ||
| D95-14 | ||
| D95-16 | ||
| D95-18 | ||
| D95-20 | ||
| D95-22 | ||
| D95-25 | ||
| D95-30 |
Indications:
| ST Color |
crown | √ |
Bridge | √ |
3-4 units bridge | √ |
5-6 units bridge | √ |
Bridges over 7 units | √ |
Cantilever bridge | √ |
Inlay bridge | √ |
Maryland bridge | √ |
Telescopic crown | √ |
Personalized abutment | √ |
Operation Guide:
1 .Place a zirconia block in your CAD/CAM machine and machine it following the manufacturer’s instructions.
2 .After machining is completed, remove the zirconia block from the CAD/CAM machine first. Then remove the framework from the zirconia block with a diamond disc. Subsequently, place the framework on a sintering tray with zirconia beads and put them in the oven for sintering.
3 .Program the furnace according to its instruction manual and zirconia block’s sintering chart, and then start sintering.
4 .Do not remove the sintered framework until it is fully cooled down. Examine the sintered framework for wall thickness, margin fit and seat fit. If necessary, make minor adjustments with a water cooled diamond tool.
5 .Make sure no wall thickness is less than 0.5mm and no connector is thinner than 9mm2.
6 .Rinse the sintered framework with water and dry completely.